Ŀ�θ������� ���ý� ������

["admin" <admin@xxxxxxxxxxxxxxx>]

4.6-stable
5.0-current 에서 GENERIC 파일을 가지고 컴파일을 했는데
로칼모니터상에서 이미지를 불러오고 나서 슬래시가 한번 움직이고 그상태에서 
부팅 메세지들이 안올라오고 멈춰버립니다. 물론 키보드도 안먹고요.
리모트상에서는 접속이 됩니다.
뭐가 잘못된건지요?
아래처럼 정상적으로 올라와야하는게 콘솔에서만 보이지 않는게 이상합니다.

test# dmesg
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.0-RELEASE #2: Sun May 11 02:32:54 GMT 2003
    root@xxxx:/usr/src/sys/i386/compile/MYKERNEL
Preloaded elf kernel "/boot/kernel/kernel" at 0xc03a7000.
Timecounter "i8254"  frequency 1193182 Hz
Timecounter "TSC"  frequency 167047196 Hz
CPU: Pentium/P55C (167.05-MHz 586-class CPU)
  Origin = "GenuineIntel"  Id = 0x543  Stepping = 3
  Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
real memory  = 33554432 (32 MB)
avail memory = 28893184 (27 MB)
pnpbios: Bad PnP BIOS data checksum
Intel Pentium detected, installing workaround for F00F bug
Initializing GEOMetry subsystem
npx0: <math processor> on motherboard
npx0: INT 16 interface
Using $PIR table, 6 entries at 0xc00fdf60
pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
isab0: <PCI-ISA bridge> at device 1.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <SiS 5591 ATA33 controller> port 0xfcd0-0xfcdf,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 at device 1.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
ed0: <NE2000 PCI Ethernet (RealTek 8029)> port 0xfce0-0xfcff irq 11 at device 13.0 on pci0
ed0: address 00:40:c7:2e:c6:02, type NE2000 (16 bit)
pci0: <display, VGA> at device 18.0 (no driver attached)
orm0: <Option ROM> at iomem 0xc0000-0xc7fff on isa0
pmtimer0 on isa0
fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A, console
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
Timecounters tick every 10.000 msec
ad0: 76319MB <ST380011A> [155061/16/63] at ata0-master UDMA33
ad2: 2060MB <SAMSUNG WA32162A> [4186/16/63] at ata1-master WDMA2
Mounting root from ufs:/dev/ad0s1a
WARNING: / was not properly dismounted
WARNING: R/W mount of / denied.  Filesystem is not clean - run fsck>W슧�h�F�v聯z뼨�)�A�
m����$?�y�◀?$?�R{.n�+돴�zwfj)m�f＂�h��+�� 溫"�㎠咽r��z�옽磨왞㎍�86(~�^숇,j