Re: Ä¿³Î¸®ºôµåÈÄ ºÎÆýà ¹®Á¦Á¡

[CHOI Junho <cjh@xxxxxxxxxxxxxx>]

시리얼 콘솔로 바뀌어 있는건 아닌지...

From: "admin" <admin@xxxxxxxxxxxxxxx>
Subject: 커널리빌드후 부팅시 문제점
Date: Sun, 11 May 2003 19:51:59 +0900

> 4.6-stable
> 5.0-current 에서 GENERIC 파일을 가지고 컴파일을 했는데
> 로칼모니터상에서 이미지를 불러오고 나서 슬래시가 한번 움직이고 그상태에서 
> 부팅 메세지들이 안올라오고 멈춰버립니다. 물론 키보드도 안먹고요.
> 리모트상에서는 접속이 됩니다.
> 뭐가 잘못된건지요?
> 아래처럼 정상적으로 올라와야하는게 콘솔에서만 보이지 않는게 이상합니다.
> 
> test# dmesg
> Copyright (c) 1992-2003 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
>         The Regents of the University of California. All rights reserved.
> FreeBSD 5.0-RELEASE #2: Sun May 11 02:32:54 GMT 2003
>     root@xxxx:/usr/src/sys/i386/compile/MYKERNEL
> Preloaded elf kernel "/boot/kernel/kernel" at 0xc03a7000.
> Timecounter "i8254"  frequency 1193182 Hz
> Timecounter "TSC"  frequency 167047196 Hz
> CPU: Pentium/P55C (167.05-MHz 586-class CPU)
>   Origin = "GenuineIntel"  Id = 0x543  Stepping = 3
>   Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
> real memory  = 33554432 (32 MB)
> avail memory = 28893184 (27 MB)
> pnpbios: Bad PnP BIOS data checksum
> Intel Pentium detected, installing workaround for F00F bug
> Initializing GEOMetry subsystem
> npx0: <math processor> on motherboard
> npx0: INT 16 interface
> Using $PIR table, 6 entries at 0xc00fdf60
> pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
> pci0: <PCI bus> on pcib0
> isab0: <PCI-ISA bridge> at device 1.0 on pci0
> isa0: <ISA bus> on isab0
> atapci0: <SiS 5591 ATA33 controller> port 0xfcd0-0xfcdf,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 at device 1.1 on pci0
> ata0: at 0x1f0 irq 14 on atapci0
> ata1: at 0x170 irq 15 on atapci0
> ed0: <NE2000 PCI Ethernet (RealTek 8029)> port 0xfce0-0xfcff irq 11 at device 13.0 on pci0
> ed0: address 00:40:c7:2e:c6:02, type NE2000 (16 bit)
> pci0: <display, VGA> at device 18.0 (no driver attached)
> orm0: <Option ROM> at iomem 0xc0000-0xc7fff on isa0
> pmtimer0 on isa0
> fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
> fdc0: FIFO enabled, 8 bytes threshold
> fd0: <1440-KB 3.5" drive> on fdc0 drive 0
> atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
> vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
> sio0: type 16550A, console
> sio1: configured irq 3 not in bitmap of probed irqs 0
> sio1: port may not be enabled
> Timecounters tick every 10.000 msec
> ad0: 76319MB <ST380011A> [155061/16/63] at ata0-master UDMA33
> ad2: 2060MB <SAMSUNG WA32162A> [4186/16/63] at ata1-master WDMA2
> Mounting root from ufs:/dev/ad0s1a
> WARNING: / was not properly dismounted
> WARNING: R/W mount of / denied.  Filesystem is not clean - run fsck

--
CHOI Junho <http://www.kr.FreeBSD.org/~cjh>     KFUG <cjh at kr.FreeBSD.org>
FreeBSD Project <cjh at FreeBSD.org>        Web Data Bank <cjh at wdb.co.kr>
Key fingerprint = 1369 7374 A45F F41A F3C0  07E3 4A01 C020 E602 60F5
--
Please look and take part in KFUG FAQ: <http://www.kr.freebsd.org/FAQ-kr/>
To Unsubscribe: send mail to majordomo@xxxxxxxxxxxxxx
with "unsubscribe questions" in the BODY of the message