[KFUG] 라데온9700에서 하드웨어 가속 문제

["최영수" <ysch0i@xxxxxxxxx>]

여러개의 질문을 동시에 올려 죄송합니다.

각각 질문을 올려야 할것 같아서 따로 올리게 되었습니다.

역시 프비5.2에서 라데온9700의 가속 기능에 관한 글을 보았습니다.

기본적인 정보는

http://people.freebsd.org/~anholt/dri/install.html

와

http://naida.chcomnet.com/?page=view&ctn=tips&id=226

를 참고했습니다. 에전 집 컴퓨터에서는 라데온9000인데 비슷하게 해서 해결을 봤는데 9700은 시작부터 안되더군요.

일단 /usr/src/sys/i386/conf/GENERIC에서

device    radeondrm
를 추가해서 커널 컴파일하고 재부팅하였습니다.

분명 다른변경 사항등을 볼때 제대로 컴파일되서 인스톨된것이 분명한데

dmesg | grep drm하면 아무것도 나오지 않습니다.

agp가 없으면 (4.X후반부터는 디폴트로 있다고 들었습니다만) 안된다구 해서

dmesg | grep agp하면 잘 잡은것 같습니다.

agp0: <Intel Generic host to PCI bridge> mem 0xe0000000-0xe3ffffff at device 0.0 on pci0

이거 자체가 로드가 안되서인지 XF86Config에도 dri, glx를 추가해주었고

/usr/src/sys/modules/drm 가서 make all install도 해주었지만... 

X윈도우에서 glxinfo를 실행해보면

direct rendering: NO로 나옵니다. 어떤 부분에서 제가 잘못한 것일까요?

아래는 dmesg의 결과입니다.

[cys@cyswork:~]$ dmesg
Copyright (c) 1992-2004 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.2.1-RELEASE-p8 #3: Thu Jun 10 22:06:23 KST 2004
    root@xxxxxxxxxxxxxxxxx:/usr/src/sys/i386/compile/CYSWORK
Preloaded elf kernel "/boot/kernel/kernel" at 0xc07dd000.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc07dd1cc.
ACPI APIC Table: <AOpen  AWRDACPI>
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Pentium(R) 4 CPU 2.00GHz (1992.62-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0xf24  Stepping = 4
  Features=0x3febfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM>
real memory  = 536805376 (511 MB)
avail memory = 515952640 (492 MB)
ioapic0 <Version 2.0> irqs 0-23 on motherboard
Pentium Pro MTRR support enabled
npx0: [FAST]
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <AOpen  AWRDACPI> on motherboard
pcibios: BIOS version 2.10
Using $PIR table, 13 entries at 0xc00fde90
acpi0: Power Button (fixed)
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x4008-0x400b on acpi0
acpi_cpu0: <CPU> port 0x530-0x537 on acpi0
acpi_cpu1: <CPU> port 0x530-0x537 on acpi0
device_probe_and_attach: acpi_cpu1 attach returned 6
acpi_tz0: <Thermal Zone> port 0x530-0x537 on acpi0
acpi_button0: <Power Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
agp0: <Intel Generic host to PCI bridge> mem 0xe0000000-0xe3ffffff at device 0.0 on pci0
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pcib1: slot 0 INTA is routed to irq 16
pci1: <display, VGA> at device 0.0 (no driver attached)
pci1: <display> at device 0.1 (no driver attached)
pci0: <serial bus, USB> at device 29.0 (no driver attached)
pci0: <serial bus, USB> at device 29.1 (no driver attached)
pci0: <serial bus, USB> at device 29.2 (no driver attached)
pci0: <serial bus, USB> at device 29.7 (no driver attached)
pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci2: <ACPI PCI bus> on pcib2
rl0: <RealTek 8139 10/100BaseTX> port 0xa000-0xa0ff mem 0xe6000000-0xe60000ff irq 22 at device 4.0 on pci2
rl0: Ethernet address: 00:01:80:31:ba:b6
miibus0: <MII bus> on rl0
rlphy0: <RealTek internal media interface> on miibus0
rlphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH4 UDMA100 controller> port 0xf000-0xf00f,0-0x3,0-0x7,0-0x3,0-0x7 at device 31.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata0: [MPSAFE]
ata1: at 0x170 irq 15 on atapci0
ata1: [MPSAFE]
pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
pcm0: <Intel ICH4 (82801DB)> port 0xc400-0xc43f,0xc000-0xc0ff mem 0xe6102000-0xe61020ff,0xe6101000-0xe61011ff irq 17 at device 31.5 on pci0
pcm0: <Avance Logic ALC650 AC97 Codec>
fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on acpi0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
acpi_cpu1: <CPU> port 0x530-0x537 on acpi0
device_probe_and_attach: acpi_cpu1 attach returned 6
orm0: <Option ROMs> at iomem 0xd0000-0xd7fff,0xc0000-0xccfff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounter "TSC" frequency 1992621152 Hz quality 800
Timecounters tick every 10.000 msec
GEOM: create disk ad0 dp=0xc4479560
ad0: 38204MB <SAMSUNG SP4002H> [77622/16/63] at ata0-master UDMA100
GEOM: create disk ad1 dp=0xc4479160
ad1: 114473MB <ST3120026A> [232581/16/63] at ata0-slave UDMA100
acd0: CDROM <GCR-8521B> at ata1-master PIO4
GEOM: create disk ad3 dp=0xc4423c60
ad3: 114473MB <ST3120026A> [232581/16/63] at ata1-slave UDMA100
Mounting root from ufs:/dev/ad0s2a

_______________________________________________
한국 FreeBSD 사용자 그룹(KFUG) questions 메일링 리스트
questions at kr.FreeBSD.org
http://www.kr.FreeBSD.org/mailman/listinfo/questions